LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1983 >> Scrambler Base, 4.2 C, Standard, T4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Servicing - A/T) >> Adjustment >> Transmission Throttle Cable/Linkage >> 999 Transmission with 4-Cylinder Engine

999 Transmission with 4-Cylinder Engine

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 1987 Jeep Wrangler, 1987 Jeep Wagoneer, 1987 Jeep Pickup, 1987 Jeep Grand Wagoneer, and 1987 Jeep Comanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise vehicle. Using a spring, hook one end on throttle control lever and other end on torque converter housing. Lower vehicle.
  2. Disconnect the ISA motor and connect Exerciser Box to ISA. Adjustment light should turn off and ready light should turn on. Press retrack button. Wait until ISA adjusts, ready light goes off and adjust light goes on.
  3. Loosen bolt on throttle control link. Pull on link end to eliminate lash. Tighten adjusting bolt. Press extend button on Exerciser Box. When ISA retracts, release button and disconnect Exerciser Box. Connect ISA wiring and remove spring from throttle control lever. Install and reconnect any parts removed and/or disconnected.
scientia non olet · About LEMON Manuals