LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1983 >> Scrambler Base, 4.2 C, Standard, T4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Servicing - A/T) >> Adjustment >> Transmission Throttle Cable/Linkage >> 727 Transmission with 6-Cylinder Engines

727 Transmission with 6-Cylinder Engines

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 1987 Jeep Wrangler, 1987 Jeep Wagoneer, 1987 Jeep Pickup, 1987 Jeep Grand Wagoneer, and 1987 Jeep Comanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect throttle control rod spring. Use spring to hold transmission throttle control lever forward, against stop. Block choke open and release fast idle cam.
  2. On carburetors equipped with throttle operated solenoid valve, turn key to "ON" position to energize solenoid. Open throttle halfway to allow solenoid to lock. Return throttle to idle position.
  3. Loosen retaining bolt on throttle control adjusting link. DO NOT  remove spring clip or nylon washer. Pull on end of link to eliminate lash. Tighten link retaining bolt. Reconnect throttle control rod spring.
scientia non olet · About LEMON Manuals