LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1983 >> Scrambler Base, 4.2 C, Standard, T4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Servicing - A/T) >> Adjustment >> Low-Reverse (Rear) Band

Low-Reverse (Rear) Band

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 1986 Jeep Wagoneer, 1986 Jeep Pickup, 1986 Jeep Grand Wagoneer, 1986 Jeep Comanche, and 1986 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise vehicle, drain transmission fluid and remove oil pan. Locate adjusting screw on rear servo lever. Loosen adjusting screw lock nut and back off about 5 turns.
  2. Tighten screw to 41 INCH lbs. (4.6 N.m) and back off indicated number of turns. See LOW-REVERSE (REAR) BAND ADJUSTMENT  . Hold adjusting screw in position and tighten lock nut to 35 ft. lbs. (48 N.m). Install oil pan and fill transmission with fluid.
    LOW-REVERSE (REAR) BAND ADJUSTMENT

    Application Back Off Screw
    Model 727 2 Turns
    Model 904 7 Turns
    Model 999 4 Turns
scientia non olet · About LEMON Manuals