LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1983 >> Scrambler Base, 4.2 C, Standard, T4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Servicing - A/T) >> Adjustment >> Transmission Throttle Cable/Linkage >> V8 Models

V8 Models

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 1984 Jeep Wagoneer, 1984 Jeep Scrambler, 1984 Jeep Pickup, 1984 Jeep Grand Wagoneer, and 1984 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect throttle control rod spring. Use spring to hold transmission throttle valve control lever against forward stop. Block choke open and release fast idle cam.
  2. On carburetors equipped with throttle operated solenoid valve, turn key to "ON" position to energize solenoid. Open throttle halfway to allow solenoid to lock. Return throttle to idle position.
  3. Loosen retaining bolt on throttle control rod adjusting link. Remove spring clip and slide nylon washer to rear of link. Push on end of link to eliminate lash and tighten retaining bolt. Install nylon washer and spring clip. Reconnect throttle control rod spring.
scientia non olet · About LEMON Manuals