LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1983 >> Scrambler Base, 4.2 C, Standard, T4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Servicing - A/T) >> Adjustment >> Transmission Throttle Cable/Linkage >> 6-Cylinder Models with 904 Transmission

6-Cylinder Models with 904 Transmission

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 1984 Jeep Wagoneer, 1984 Jeep Scrambler, 1984 Jeep Pickup, 1984 Jeep Grand Wagoneer, and 1984 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove air cleaner. Hold throttle control lever rearward against its stop. Block choke plate open and set carburetor linkage completely off fast idle cam.
  2. Unlock throttle control cable by lifting "T" shaped adjuster clamp with small screwdriver. Move cable outer sheath forward to remove any cable load on throttle cable bellcrank.
  3. Adjust cable by moving cable and sheath rearward until there is no lash between cable and throttle linkage. Lock cable by pressing "T" shaped clamp downward until clamp snaps into place. Install and reconnect any parts removed and/or disconnected.
scientia non olet · About LEMON Manuals