LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1983 >> Scrambler Base, 4.2 C, Standard, T4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Servicing - A/T) >> Adjustment >> Transmission Throttle Cable/Linkage >> 4-Cylinder Models with 904 Transmission

4-Cylinder Models with 904 Transmission

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 1984 Jeep Wagoneer, 1984 Jeep Scrambler, 1984 Jeep Pickup, 1984 Jeep Grand Wagoneer, and 1984 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect throttle control rod spring at carburetor. Raise vehicle. Use throttle control rod spring to hold transmission throttle control lever forward against stop. Hook one end of a spring on throttle control lever and other end on throttle linkage bellcrank bracket attached to converter housing.
  2. Lower vehicle. Bloke choke open and set carburetor throttle off fast idle cam. Turn ignition lock to "ON" position to energize solenoid. Open throttle halfway to allow solenoid to lock and return carburetor to idle position.
  3. Loosen retaining bolt on throttle control adjusting link. Do not remove spring clip and nylon washer. Pull on end of link to eliminate lash and tighten throttle control rod spring from linkage. Lower vehicle. Install spring on throttle control rod.
scientia non olet · About LEMON Manuals