LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1983 >> Scrambler Base, 4.2 C, Standard, T4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Servicing - A/T) >> Adjustment >> Low-Reverse (Rear) Band

Low-Reverse (Rear) Band

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 1988 Dodge Ramcharger, 1988 Dodge Ram Wagon, 1988 Dodge Ram Van, 1988 Dodge Pickup, and 1988 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain transmission and remove oil pan. Locate low-reverse band adjusting screw on rear servo lever. Loosen adjusting screw lock nut and back off screw about 5 turns. Ensure screw turns freely in lever. Using Wrench (C-3380-A), tighten adjusting screw to 72 INCH lbs. (8 N.m).
  2. Back off rear adjusting screw. See LOW-REVERSE BAND ADJUSTMENT  . Hold adjusting screw in position and tighten lock nut to 35 ft. lbs. (47 N.m). Clean oil pan, install new gasket with pan and fill transmission with fluid.
    LOW-REVERSE BAND ADJUSTMENT

    Application Back Off Screw
    A-727 2 Turns
    A-904T/A-998/A-999 4 Turns
    Fig 1: Low-Reverse Band Adjusting Screw Location
    G35234
scientia non olet · About LEMON Manuals