LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1983 >> Scrambler Base, 4.2 C, Standard, T4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Servicing - A/T) >> Adjustment >> Neutral Safety Switch

Neutral Safety Switch

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 1987 Dodge Ramcharger, 1987 Dodge Ram Wagon, 1987 Dodge Ram Van, 1987 Dodge Pickup, and 1987 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. With transmission linkage properly adjusted, switch should allow starter operation in Park and Neutral only. To test switch, remove wire connector and test for continuity between center pin of switch and case. Continuity should exist only with transmission in "P" or "N".
  2. Check for continuity between 2 outer pins. Continuity should exist with transmission in reverse, only. There should be no continuity between either outside pin or transmission case.
    NOTE: Ensure gearshift linkage is properly adjusted before replacing a switch that tests bad.
  3. To replace, remove switch from case and allow fluid to drain. Move selector lever to "P" and "N" positions and check that switch operating fingers are centered in switch opening. Install new switch and seal. Retest switch for continuity and add transmission fluid.
    Fig 1: Back-Up Light/Neutral Safety Switch
    G35241

    When installing new switch, tghten to 24 ft. lbs. (33 N.m).

scientia non olet · About LEMON Manuals