LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1983 >> Scrambler Base, 4.2 C, Standard, T4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Servicing - A/T) >> Adjustment >> KICKDOWN (Front) Band

KICKDOWN (Front) Band

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 1987 Dodge Ramcharger, 1987 Dodge Ram Wagon, 1987 Dodge Ram Van, 1987 Dodge Pickup, and 1987 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Locate kickdown band adjusting screw at left side of transmission case, near throttle lever shaft. See Fig 1. Loosen adjusting screw lock nut and back off 5 turns. Ensure adjusting screw turns freely in case.
  2. Using Wrench (C-3380-A) with Adapter (C-3705), tighten adjusting screw to 48 INCH lbs. (5 N.m). If adapter is not used, tighten adjusting screw to 72 INCH lbs. (8 N.m).
  3. Back off front adjusting screw. See KICKDOWN BAND ADJUSTMENT . Hold adjusting screw in position and tighten lock nut to 35 ft. lbs. (47 N.m).
    KICKDOWN BAND ADJUSTMENT

    Application Back Off Screw
    All Models 2 1/2 Turns
    Fig 1: Adjusting Kickdown Band
    G35233

    With band properly adjusted, tighten lock nut to 35 ft. lbs. (47 N.m).

scientia non olet · About LEMON Manuals