LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1983 >> Scrambler Base, 4.2 C, Standard, T4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Servicing - A/T) >> Adjustment >> Low-Reverse Band (Rear) >> Rear Wheel Drive Models

Rear Wheel Drive Models

WARNING: This page is about a different car, the 1985 Dodge Ramcharger, 1985 Dodge Ram Wagon, 1985 Dodge Ram Van, 1985 Dodge Pickup, and 1985 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain transmission and remove oil pan. Locate low-reverse band adjusting screw on rear servo lever.
  2. Loosen adjusting screw lock nut approximately 5 turns and make sure screw turns freely in lever. Using special wrench (C3380-A), tighten adjusting screw to 72 INCH lbs. (8.1 N.m).
  3. Back off adjusting screw specified number of turns as given in Low-Reverse Band Adjustment table. Hold adjusting screw in position and tighten lock nut to 30 ft. lbs. (41 N.m). Clean oil pan. Install new gasket with pan and fill transmission with fluid.
scientia non olet · About LEMON Manuals