LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1983 >> Scrambler Base, 4.2 C, Standard, T4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Servicing - A/T) >> Adjustment >> Low-Reverse Band (Rear) >> Front Wheel Drive Models

Front Wheel Drive Models

WARNING: This page is about a different car, the 1985 Dodge Ramcharger, 1985 Dodge Ram Wagon, 1985 Dodge Ram Van, 1985 Dodge Pickup, and 1985 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain transaxle and remove oil pan. Apply 30 psi (2.1 kg/cm2 ) air pressure to low-reverse servo and measure gap between band ends. If less than .080" (2.0 mm), band is excessively worn and should be placed.
  2. To adjust band, loosen lock nut approximately 5 turns and tighten adjusting screw to 41 INCH lbs. (4.6 N.m). Back off adjusting screw as specified in LOW-REVERSE BAND ADJUSTMENT  . Hold screw in position and tighten lock nut.
    Fig 1: Low-Reverse Band Adjustment (Rear) Screw Location
    G35234
    LOW-REVERSE BAND ADJUSTMENT

    Application Back Off Screw
    A-413 & A-470 3 1/2 Turns
    A-904-LA, A-904T & A-999 4 Turns
    A-727 2 Turns
scientia non olet · About LEMON Manuals