LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1983 >> Scrambler Base, 4.2 C, Standard, T4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Servicing - A/T) >> Adjustment >> Shift Linkage >> Floor Shift (RWD Models)

Floor Shift (RWD Models)

WARNING: This page is about a different car, the 1984 Dodge Ramcharger, 1984 Dodge Ram Wagon, 1984 Dodge Ram Van, 1984 Dodge Pickup, and 1984 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Loosen adjustable rod swivel lock screw, place selector in "PARK", and move shift lever on transmission all the way to rear (park position).
  2. Adjust swivel so no load is placed on linkage in either direction, then tighten swivel lock screw. Check adjustment so shift effort is free, detents are solid, and all gate stops are positive.
  3. Detent position should be close enough to gate stops in "NEUTRAL" and "DRIVE" so shift selector lever will not remain out of detent position when placed against gate and released. Starter should operate only in "NEUTRAL" or "PARK" positions.
    Fig 1: Floor Shift Linkage Adjustment on RWD Models
    G35239

    Swivel located near transmission housing.

scientia non olet · About LEMON Manuals