LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1983 >> Scrambler Base, 4.2 C, Standard, T4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Servicing - A/T) >> Adjustments >> Low-Reverse Band (Rear) >> Rear Wheel Drive Models

Rear Wheel Drive Models

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 1983 Plymouth Voyager, 1983 Dodge Ramcharger, 1983 Dodge Ram Wagon, 1983 Dodge Ram Van, and 1983 Dodge Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain transmission and remove oil pan. Locate low-reverse band adjusting screw on rear servo lever.
  2. Loosen adjusting screw lock nut approximately 5 turns and make sure screw turns freely in lever. Using special wrench (C3380-A), tighten adjusting screw to 72 INCH lbs. (8.1 N.m.).
  3. Back off adjusting screw specified number of turns as given in LOW-REVERSE BAND ADJUSTMENT  . Hold adjusting screw in position and tighten lock nut to 30 ft. lbs. (41 N.m.). Clean oil pan. Install new gasket with pan and fill transmission with fluid.
Fig 1: Low-Reverse Band Adjustment (Rear) Screw Location
G35234
LOW-REVERSE BAND ADJUSTMENT

Application Back Off Screw
A-904T & A-999 4 Turns
A-727 2 Turns
scientia non olet · About LEMON Manuals