LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1983 >> Scrambler Base, 4.2 C, Standard, T4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Servicing - A/T) >> Adjustments >> Low-Reverse Band (Rear)

Low-Reverse Band (Rear)

WARNING: This page is about a different car, the 1988 Plymouth Gran Fury, 1988 Dodge Diplomat, and 1988 Chrysler Fifth Avenue. However, it is still accessible from the selected car via links, so may be relevant.

Low-Reverse band adjusting screw is located on rear servo lever. Transmission oil pan must be removed to provide access to band adjusting screw. See Fig 1 .

  1. Drain transmission and remove oil pan. Loosen band adjusting screw lock nut about 5 turns. Ensure adjusting screw turns freely in case. Tighten screw to 72 INCH lbs. (8 N.m).
  2. Back off adjusting screw specified number of turns given in LOW-REVERSE BAND ADJUSTMENT  . Hold in this position and tighten lock nut. Install oil pan and fill transmission with fluid.
Fig 1: Low-Reverse Band Adjustment (Rear) Screw Location
G35234
LOW-REVERSE BAND ADJUSTMENT

Application Back Off Screw
A-904-LA 4 Turns
A-727 2 Turns
scientia non olet · About LEMON Manuals