Power Brake Unit: Disassembly
- Remove push rod boot, silencer, front housing seal, grommet and vacuum check valve. Scribe a mark on front and rear housing for reassembly reference. Attach front housing to holding fixture (J-22805-01).
- Place spanner wrench (J09504) over rear housing studs, press down, and turn counterclockwise to unlock housings. Carefully separate housings. Remove power piston group, power piston return spring, and power piston bearing. Remove push rod, reaction retainer and power head silencer.
- Grasp assembly at outside edge of divider and diaphragms. Hold with push rod down against a hard surface. Use a slight force or impact to dislodge diaphragm retainer. Remove primary diaphragm, primary support plate and secondary power piston bearing. Remove housing divider, secondary support plate and diaphragm and power piston assembly.