LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2023 >> XF R-Dynamic SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 98 (Starting System - V6 S/C 3.0L Petrol -- XE (X760)) >> Starting System - V6 S/C 3.0L Petrol >> Starter Motor >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
  • This procedure contains illustrations showing certain components removed to provide extra clarity.
  1. Disconnect the startup battery ground cable.

    Refer to: Battery Disconnect and Connect .

  2. Raise and support the vehicle using a suitable 2 post lift.

    Refer to: Lifting .

  3. Remove the air deflector.

    Refer to: Air Deflector .

  4. Remove the right catalytic converter.

    Refer to: Right Catalytic Converter .

  5. Release clips.
    G11308033
  6. Disconnect the electrical connector from the starter motor.
    G11308034
  7. Disconnect the electrical connector from the starter motor.
    G11308035
  8. Remove the 2 bolts and the heatshield.
    G11308036

    Torque Specification: 6 Nm 

  9. Remove the lower starter motor bolt.
    G11308037
  10. Remove the upper bolt and remove the starter motor.
    NOTE: The upper bolt will remain captive.
    G11308038
scientia non olet · About LEMON Manuals