LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2023 >> XF R-Dynamic SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 98 (Starting System - V6 S/C 3.0L Petrol -- XE (X760)) >> Starting System - V6 S/C 3.0L Petrol >> Starter Motor >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the starter motor.

    Torque Specification: 48 Nm 

  2. Install the lower starter motor bolt.

    Torque Specification: 48 Nm 

  3. Install the heatshield.

    Torque Specification: 6 Nm 

  4. Connect the electrical connector.

    Torque Specification: 7 Nm 

  5. Connect the electrical connector.

    Torque Specification: 12 Nm 

  6. Secure the clips.
  7. install the right catalytic converter.

    Refer to: Right Catalytic Converter .

  8. Install the air deflector.

    Refer to: Air Deflector .

  9. Connect the startup battery ground cable.

    Refer to: Battery Disconnect and Connect .

scientia non olet · About LEMON Manuals