Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Make sure that the wiring harness is not twisted or damaged on removal. Failure to follow this instruction may result in damage to the vehicle.
Take extra care not to damage the wiring harness clips.
Note the position of the wiring harnesses clips to aid installation.
Removal steps in this procedure contains installation details.

NOTE: Some variation in the illustrations may occur, but the essential information is always correct.

Refer to: DESCRIPTION AND OPERATION (Supplemental Restraint System (SRS)).
Refer to: Battery Disconnect and Connect .
Refer to: Loadspace Trim Panel LH .
Refer to: Loadspace Trim Panel RH .
NOTE: This procedure must be carried out on both sides.

Refer to: Rear Seat Bolster
Refer to: Parcel Shelf .
Refer to: Headliner .
NOTE:
- This procedure must be carried out on both sides.
- Right illustration shown, left is similar
Refer to: Instrument Panel Console (501-12, Removal and Installation).
NOTE: This procedure must be carried out on both sides.

Refer to: Cowl Side Trim Panel .