LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2023 >> XF R-Dynamic SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Rear Drive HALFSHAFTS -- XE (X760)) >> Rear Drive HALFSHAFTS >> Outer Constant Velocity Joint Boot (G2085467) >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
  1. CAUTION: Extreme cleanliness must be exercised when handling these components.
    NOTE: Clean the constant velocity (CV) joint, removing as much of the old grease as possible.

    Clean and inspect the components, renew if damaged or worn.

  2. G11305923
    1. Pack the outer CV joint with the grease supplied.
    1. Install the new outer CV joint boot.

    Renew Part: Outer constant velocity joint boot kit. 

  3. G11305924

    Make sure the outer CV joint boot is correctly installed.

  4. G11305887

    Using a suitable tool install the new CV joint boot clips.

    General Equipment:  Constant velocity (CV) boot clamp pliers

  5. Install the inner constant velocity (CV) joint boot.

    Refer to: Inner Constant Velocity Joint Boot  (205-05 Rear Drive Halfshafts, Removal and Installation).

scientia non olet · About LEMON Manuals