LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2023 >> XF R-Dynamic SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 49 (Driveshaft -- XE (X760)) >> Driveshaft >> Driveshaft - INGENIUM I4 2.0L Petrol >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
  • This procedure contains illustrations showing certain components removed to provide extra clarity.
  1. Raise and support the vehicle on a suitable 2 post lift.

    Refer to: Lifting .

  2. Remove the engine cover.

    Refer to: Engine Cover - Ingenium I4 2.0L Petrol .

  3. G11305760

    Release the emergency park release cable.

  4. Remove the exhaust system.

    Refer to: Exhaust System .

  5. G11305761
    • Remove the 4 bolts.
    • Remove the 2 clips.
    • Remove the heatshield.
  6. G11305762
    • Mark the position of the driveshaft flange in relation to the output flange.
    • Remove and discard the 6 bolts.
  7. Mark the position of the driveshaft in relation to the rear drive axle flange.
    G11305763
  8. Remove and discard the 6 bolts.
    G11305764
  9. WARNING: This requires the aid of another technician.
    G11305765
scientia non olet · About LEMON Manuals