LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2023 >> XF R-Dynamic SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 36 (Exhaust System - INGENIUM I4 2.0L Diesel -- XE (X760)) >> Exhaust System - INGENIUM I4 2.0L Diesel >> Catalytic Converter >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Observe due care when working near a hot exhaust system.
NOTE:
  • Removal steps in this procedure may contain installation details.
  • Some components shown removed for clarity.
  • Some variation in the illustrations may occur, but the essential information is always correct.
  1. Refer to: Engine Cover - INGENIUM I4 2.0L Diesel .
  2. Raise and support the vehicle.
    WARNING: Make sure to support the vehicle with axle stands.
  3. Refer to: Exhaust System - Vehicles Without: Diesel Exhaust Fluid .
  4. G11314611

    Torque Specification: 25 Nm 

  5. G11314612
  6. G11314613

    Torque Specification: 25 Nm 

  7. G11314607
  8. NOTE: Install a new clamp.
    G11314615

    Torque Specification: 10 Nm 

  9. G11314610

    Torque Specification: 48 Nm 

scientia non olet · About LEMON Manuals