Pinpoint Test B: Diagnostic Module Tank Leakage Tests

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

TEST CONDITIONS

DETAILS/RESULTS/ACTIONS

B1: DIAGNOSTIC MODULE TANK LEAKAGE TEST 1
1. Using the manufacturer approved diagnostic system, perform routine - Evaporative System Diagnostic Check - and use the combustible gas detector to check for leaks
Was a leak detected around the fuel filler cap?

Yes: GO to B2 .

No: GO to B3 .
B2: DIAGNOSTIC MODULE TANK LEAKAGE TEST 2
1. Tighten the fuel filler cap securely (until 3 clicks are heard)
2. Using the manufacturer approved diagnostic system, perform routine - Evaporative System Diagnostic Check - and use the combustible gas detector to check for leaks
  Test passed?
- Yes : Repair complete. Advise the customer to always tighten the fuel filler cap securely (until 3 clicks are heard)
- No: GO to B3 .
B3: DIAGNOSTIC MODULE TANK LEAKAGE TEST 3
1. Consider the previous test results
Was a leak detected by the routine?
- Yes: GO to B4 .
- No : Diagnostic module tank leakage system circuit fault. Check DTCs and refer to the relevant DTC Index. Repair the circuit fault as necessary. GO to Pinpoint Test E .
  B4: DIAGNOSTIC MODULE TANK LEAKAGE TEST 4
1. Consider the previous test results
Was the source of the leak identified?
- Yes : Repair as necessary. GO to Pinpoint Test E .
- No : GO to Pinpoint Test C .