Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

- Install the secondary bulkhead right panel.
- Install and tighten 5 bolts
  Torque Specification: 5.4 Nm
Connect the 2 electrical connectors.
Torque Specification: 3.6 Nm
- Install the engine compartment brace.
- Install and tighten the 4 bolts.
  Torque Specification: 55 Nm
Install the cowl panel.
Refer to: Cowl Vent Screen .
Install the engine cover.
Refer to: Engine Cover - INGENIUM I4 2.0L Petrol .
Connect the startup battery ground cable.
Refer to: Battery Disconnect and Connect .