LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2023 >> XF R-Dynamic SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 281 (Parking Brake And Actuation -- XE/(760)) >> Parking Brake And Actuation (G1822069) >> Removal And Installation >> Electric Park Brake Actuator - Project 8 (G2252405) >> Installation

Electric Park Brake Actuator - Project 8 (G2252405): Installation

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
    • Install the new O-ring seal.

      Renew Part: Electric park brake actuator fitting kit  Quantity: 1. 

    • Install the Electric Park Brake (EPB) actuator.
    • Install and tighten the 2 new bolts.

      Torque  : 8Nm 

    • Connect the electrical connector.
  2. Connect the startup battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT

  3. NOTE: This step is only required if the diagnostic equipment is not available.

    Deactivate the EPB service mode.

    Refer to: ELECTRIC PARK BRAKE SERVICE MODE ACTIVATION AND DEACTIVATION 

  4. Connect the Jaguar Land Rover (JLR) approved diagnostic equipment and configure the EPB.

    General Equipment: Jaguar Land Rover approved diagnostic equipment 

scientia non olet · About LEMON Manuals