LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2023 >> XF R-Dynamic SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Parking Brake & Actuation -- XE (X760)) >> Parking Brake And Actuation >> Electric Park Brake Actuator >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Removal steps in this procedure may contain installation details.
  1. Connect the diagnostic tool and set the electronic park brake (EPB) to the maintenance position.
  2. Refer to: Electronic Parking Brake (EPB) Service Mode Activation and Deactivation .
    NOTE: This step is only required if the diagnostic tool is not available.
  3. Raise and support the vehicle.
    WARNING: Make sure to support the vehicle with axle stands.
  4. G11308680
  5. NOTE: Remove and discard the O-ring seal.
    G11308661

    Renew Part: Electric park brake actuator O-ring seal Quantity: 1.

    Torque: 8 Nm 

scientia non olet · About LEMON Manuals