LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2023 >> XF R-Dynamic SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Rear Disc Brake -- XE (X760)) >> Rear Disc Brake - V6 S/C 3.0L Petrol/INGENIUM I4 2.0L Diesel >> Brake Pads (G1822059) >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean the brake caliper housing and anchor plate using brake cleaning fluid.
    WARNING: Do not use compressed air to clean brake components. Dust from friction materials can be harmful if inhaled.
    G11308670
  2. Inspect the caliper piston and slide pin seals for damage.
    G11308662
  3. G11308672
  4. To install, reverse the removal procedure.
    CAUTION: Make sure that the brake hose is not twisted and is correctly located.
  5. Refer to: Wheel and Tire .
  6. Repeat the above procedure for the other side.
  7. Depress the brake pedal several times, check the fluid level in the brake fluid reservoir and top-up with brake fluid if necessary.
  8. Calibrate the electric parking brake (EPB) using the diagnostic tool.
  9. NOTE: This step is only required if the diagnostic tool is not available.

    Refer to: Electronic Parking Brake (EPB) Service Mode Activation and Deactivation .

  10. NOTE: This step is only required if the vehicle has no battery power.

    Refer to: Electronic Parking Brake (EPB) Release When the Vehicle Has No Electrical Power .

scientia non olet · About LEMON Manuals