Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: If the brake pad wear warning light has been activated, a new brake pad wear sensor must be installed.

CAUTION: Brake fluid will damage paint finished surfaces. If spilled, immediately remove the fluid and clean the area with water.

NOTE: Removal steps in this procedure may contain installation details.

Connect the diagnostic tool and set the electronic park brake (EPB) to the maintenance position.
NOTE: This step is only required if the diagnostic tool is not available.

Refer to: Electronic Parking Brake (EPB) Service Mode Activation and Deactivation .
NOTE: This step is only required if the vehicle has no battery power.

Refer to: Electronic Parking Brake (EPB) Release When the Vehicle Has No Electrical Power .
Raise and support the vehicle.
WARNING: Make sure to support the vehicle with axle stands.
Refer to: Wheel and Tire .
Inspect the brake pad wear sensor for signs of wear or damage. Install a new sensor if necessary.
CAUTION: The brake pad wear indicator sensor is easily damaged. Do not use a lever to remove the sensor. Use fingers only.
CAUTION:
- Inspect the brake hose sealing washers for signs of damage, if damage is present discard the sealing washers.
- Be prepared to collect escaping fluids.
NOTE: Make sure that all openings are sealed.

Torque Specification: 32 Nm
Remove the flexible brake hose.
CAUTION: Be prepared to collect escaping fluids.

NOTE: Make sure that all openings are sealed.

Renew Part: Brake hose Quantity: 1.

Torque Specification: 15 Nm
Torque Specification: 28 Nm
CAUTION: Remove and discard the O-ring seal.

NOTE: Do not disassemble further if the component is removed for access only.

Torque Specification: 8 Nm