LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2023 >> XF R-Dynamic SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Rear Disc Brake -- XE (X760)) >> Rear Disc Brake - V6 S/C 3.0L Petrol/INGENIUM I4 2.0L Diesel >> Brake Caliper (G1822055) >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the caliper piston and slide pin seals for damage.
    G11308662
  2. To install, reverse the removal procedure.
    CAUTION:
    • Make sure that a new flexible brake hose assembly is to be installed.
  3. Bleed the brake system.

    Refer to: Brake System Bleeding .

  4. Calibrate the electric parking brake (EPB) using the diagnostic tool.
  5. NOTE: This step is only required if the diagnostic tool is not available.

    Refer to: Electronic Parking Brake (EPB) Service Mode Activation and Deactivation .

  6. NOTE: This step is only required if the vehicle has no battery power.

    Refer to: Electronic Parking Brake (EPB) Release When the Vehicle Has No Electrical Power .

scientia non olet · About LEMON Manuals