LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2023 >> XF R-Dynamic SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Electronic Engine Controls - V6 S/C 3.0L Petrol -- XE (X760)) >> Electronic Engine Controls - V6 S/C 3.0 L Petrol >> Right Mid Catalyst Heated Oxygen Sensor >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
  • This procedure contains illustration showing certain components removed to provide extra clarity.
  1. Raise and support the vehicle on a suitable 2 post lift.

    Refer to: Lifting .

  2. Remove the engine undershield.
    G00565419
  3. CAUTION:
    • If accidentally dropped or knocked install a new sensor.
    • Make sure that the mating faces are clean and free of foreign material.
    • Make sure the HO2S wiring harness is not twisted more than 180 degrees and is not in contact with the exhaust.
    G00565421
    • Disconnect the electrical connector and release the clips.
    • Using the special tool, remove the heated oxygen sensor (HO2S).

      Special Tool(s):  JLR-303-1666

scientia non olet · About LEMON Manuals