LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2023 >> XF R-Dynamic SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Electronic Engine Controls - V6 S/C 3.0L Petrol -- XE (X760)) >> Electronic Engine Controls - V6 S/C 3.0 L Petrol >> Right Heated Oxygen Sensor >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
  1. NOTE: If the original sensor is to be installed, apply lubricant meeting specification ESE-M12A4-A to the thread of the sensor.
    • Using the special tool install the Heated Oxygen Sensor (HO2S) LH

      Special Tool(s):  310-121

      Torque Specification: 48 Nm 

    • Connect the electrical connect and secure the clips.
  2. Install the exhaust system.

    Refer to: Exhaust System .

  3. Install the air deflector.

    Refer to: Air Deflector .

scientia non olet · About LEMON Manuals