LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2023 >> XF R-Dynamic SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Electronic Engine Controls - V6 S/C 3.0L Petrol -- XE (X760)) >> Electronic Engine Controls - V6 S/C 3.0 L Petrol >> Post Catalyst Heated Oxygen Sensor >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • This procedure contains some variation in the illustration depending on the vehicle specification, but essential information is always correct.
  • This procedure contains illustrations showing certain components removed to provide extra clarity.
  1. Raise and support the vehicle on a suitable 2 post lift.

    Refer to: Lifting .

  2. Remove the transmission support insulator.

    Refer to: Transmission Support Insulator (Vehicles With: 8HP45 8-Speed Automatic Transmission RWD).

  3. CAUTION:
    • Make sure the HO2S wiring harness is not twisted more than 180 degrees and is not in contact with the exhaust.
    • If accidentally dropped or knocked install a new sensor.
    • Make sure that the mating faces are clean and free of foreign material.
    G11308509
  4. Disconnect the electrical connector and release the clips.
  5. Using the special tool remove the Heated Oxygen Sensor (HO2S).

    Special Tool(s):  310-121

scientia non olet · About LEMON Manuals