LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2023 >> XF R-Dynamic SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Electronic Engine Controls - V6 S/C 3.0L Petrol -- XE (X760)) >> Electronic Engine Controls - V6 S/C 3.0 L Petrol >> Manifold Absolute Pressure Sensor >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • Removal steps in this procedure may contain installation details.
  • Some variation in the illustrations may occur, but the essential information is always correct.
  1. Refer to: Secondary Bulkhead Panel LH - V6 S/C 3.0L Petrol (Removal and Installation).
  2. G11308496

    Torque Specification: 10 Nm 

  3. G11308497

    Torque Specification: 10 Nm 

  4. G11308498

    Torque Specification: 10 Nm 

  5. Reposition and secure the wiring harness.
    G11308499
  6. G11308500
  7. Use a suitable small ratchet to access the bolt.
    G11308501
  8. CAUTION:
    • Take extra care not to drop the bolt.
    • Make sure that the sensor is removed straight back, as this prevents the O-ring seal catching on the housing.
    G11308502

    Torque Specification: 5 Nm 

scientia non olet · About LEMON Manuals