LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2023 >> XF R-Dynamic SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Electronic Engine Controls - V6 S/C 3.0L Petrol -- XE (X760)) >> Electronic Engine Controls - V6 S/C 3.0 L Petrol >> Engine Control Module >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • Removal steps in this procedure may contain installation details.
  • Some variation in the illustrations may occur, but the essential information is always correct.

All vehicles 

  1. Disconnect the battery ground cable.

    Refer to: Battery Disconnect and Connect (General Procedures).

  2. Refer to: Cowl Vent Screen (Removal and Installation).

Left-hand drive vehicles 

  1. G11308429
  2. G11308430
  3. NOTE: If equipped.
    G11308431
  4. G11308432

    Torque Specification: 7 Nm 

  5. NOTE: Do not disassemble further if the component is removed for access only.
    G11308433

    Torque Specification: 7 Nm 

Right-hand drive vehicles 

  1. G11308434

    Torque Specification: 3.6 Nm 

  2. G11308435
  3. G11308436
  4. G11308437

    Torque Specification: 7 Nm 

  5. NOTE: Do not disassemble further if the component is removed for access only.
    G11308438

    Torque Specification: 7 Nm 

scientia non olet · About LEMON Manuals