Right Exhaust Back Pressure Sensor (G2401312): Installation

WARNING: This page is about a different car, the 2020 Jaguar XF and 2019 Jaguar XF. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: This step is only required if previously removed.
- Install the bracket to the differential pressure sensor.
- Install and tighten the bolt.
Torque : 9 Nm
- Install the pipe to the differential pressure sensor hose.
- Secure the clip.
- Install the bolt finger tight at this stage.
- Install the differential pressure sensor assembly.
- Install and tighten the 2 nuts.
  Torque : 9 Nm
- Connect the electrical connector.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Install and tighten the banjo bolt.
  Torque : 50 Nm
- Fully tighten the bracket bolt.
Torque : 9 Nm
Install the right air cleaner.
Refer to: RIGHT AIR CLEANER
Install the engine cover.
Refer to: ENGINE COVER - V6 S/C 3.0L PETROL