Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Nuts and bolts must be tightened with vehicle at normal ride height

NOTE:

Some variation in the illustrations may occur, but the essential information is always correct.
Some components shown removed for clarity.
Removal steps in this procedure may contain installation details.

Raise and support the vehicle.
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Refer to: Rear Shock Absorber .
CAUTION: Discard the nut and bolt.

Renew Part: Toe link to knuckle nut and bolt Quantity: 1

Torque Specifications:

Stage 1: 60 Nm

Stage 2: 60°
NOTE: Discard the nuts and bolts.

Renew Part: Integral link nuts and bolts Quantity: 1

Torque Specifications:

Stage 1: 40 Nm

Stage 2: 60°
CAUTION: Discard the nut.

Renew Part: Stabilizer bar link nuts Quantity: 1

Torque Specifications: 60 Nm
Using a suitable stand, support the lower arm.
CAUTION: Discard the bolt.

Renew Part: Lower control arm bolt(s) Quantity: 1

Torque Specifications:

Stage 1: 110 Nm

Stage 2: 60°