LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2023 >> XF R-Dynamic SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 117 (Electronic Engine Controls - INGENIUM I4 2.0L Petrol -- XE (X760)) >> Electronic Engine Controls - INGENIUM I4 2.0L Petrol >> Exhaust Camshaft Position Sensor >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
  1. NOTE:
    • Apply a thin film of Castrol Classic GP-50 to the camshaft position sensor bore.
    • Install the camshaft position sensor.
    • Renew Part: Camshaft position sensor O-ring seal Quantity: 1.
    • Install the retaining bolt.

      Torque Specification: 8 Nm 

  2. Connect the electrical connector.
  3. Connect the breather pipe.
  4. Install the engine cover.

    Refer to: Engine Cover - Ingenium I4 2.0L Petrol .

scientia non olet · About LEMON Manuals