LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2023 >> XF R-Dynamic SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 109 (Engine System - General Information -- XE (X760)) >> Engine System - General Information >> Crankshaft End Play - INGENIUM I4 2.0L Diesel >> General Procedures

General Procedures

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
12.21.26 CRANKSHAFT END FLOAT - CHECK AND ADJUST 2000 CC, INGENIUM DIESEL 2
  1. For additional information, refer to: Crankshaft Pulley .
  2. Move crankshaft rearwards, using a magnetic base position the Dial Test Indicator (DTI) gauge on end of crankshaft and zero dial test indicator.
    G11308863
  3. Move crankshaft forwards, measure and record end-float figure obtained.
    G11308864
    • If the value is out of the specification, install new thrust half rings to take up the end float and repeat the measurement.
    • Minimum crankshaft end-float 0.15MM.
    • Maximum crankshaft end float 0.35MM.
    • For additional information, refer to: Specifications .
scientia non olet · About LEMON Manuals