LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2023 >> XF R-Dynamic SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 101 (Front Suspension -- XE (X760)) >> Front Suspension >> Wheel Knuckle - AWD (G1899209) >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: The lower arm ball joint can be damaged by excessive articulation. The wheel knuckle must be fully supported at all times. Do not allow the wheel knuckle to hang on the lower arm. Failure to follow this instruction will result in damage to vehicle.
NOTE:
  • Some components shown removed for clarity.
  • Removal steps in this procedure may contain installation details.
  • Some variation in the illustrations may occur, but the essential information is always correct.
  1. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

    Raise and support the vehicle.

  2. Refer to: Wheel and Tire
  3. CAUTION: Do not use air tools to remove the driveshaft nut.
    NOTE: Retain the nut for use in the installation procedure.
    G11296610
  4. G11305515

    Torque Specification: 9 Nm 

  5. G11305516
  6. G11305444
  7. CAUTION:
    • Discard the bolts.
    • Make sure that the brake hose does not support the full weight of the brake caliper assembly.
    G11305518

    Renew Part: Brake caliper housing bolt(s) Quantity: 1.

    Torque Specifications: 

    Stage 1: 70 Nm 

    Stage 2: 120° 

  8. CAUTION: Discard the nut.
    G11305519

    Torque Specification: 133 Nm 

  9. CAUTION: Discard the nut.
    G11296550

    Renew Part: Stabilizer bar link upper nut Quantity: 1.

    Torque Specification: 60 Nm 

  10. G11305521

    Loosen, but do not fully remove the nut.

  11. G11305522

    Special Tool(s):  JLR-204-793

    Torque Specification: 60 Nm 

  12. CAUTION: Discard the nut.
    G11305523

    Renew Part: Ball joint nut(s) and washer(s) Quantity: 1.

    Torque Specification: 185 Nm 

  13. G11296620

    Special Tool(s):  205-857

  14. Remove the special tool.
  15. CAUTION: Discard the nut and bolt.
    G11305447

    Renew Part: Wheel knuckle nut and bolt Quantity: 1.

    Torque Specification: 60 Nm 

  16. G11305526

    Torque Specification: 20 Nm 

  17. G11305527

    Torque Specification: 9 Nm 

  18. CAUTION: Do not attempt to release the wheel hub by hitting it with a hammer directly, loosen the wheel hub retaining bolts partially before applying an even amount of force to the head of each bolts to release the wheel hub from the wheel knuckle. Failure to follow this instruction may cause damage to the component.
G11296563
scientia non olet · About LEMON Manuals