Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Nuts and bolts must be tightened with vehicle at normal ride height.

NOTE:

Some variation in the illustrations may occur, but the essential information is always correct.
Some components shown removed for clarity.
Removal steps in this procedure may contain installation details.

WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

Raise and support the vehicle.
Remove the front wheel and tire.
For additional information, refer to: Wheel and Tire
Remove the front stabilizer bar link.
For additional information, refer to: Front Stabilizer Bar Link - RWD .
CAUTION: Discard the bolts.

NOTE: Using a suitable tie strap, position and secure the component to one side.

Renew Part: Brake caliper carrier bolt(s), Quantity: 2.

Torque Specifications:

Stage 1: 70 Nm

Stage 2: 120°
CAUTION: Discard the nut and bolt.

Renew Part: Upper control arm retaining nut and bolt, Quantity: 1.

Torque Specification: 60 Nm
NOTE: If equipped.
CAUTION: Discard the nuts.

Renew Part: Shock absorber upper mounting nuts, Quantity: 3.

Torque Specification: 27.5 Nm
CAUTION: Bolt must be tightened with vehicle at the normal ride height.

NOTE: Do not disassemble further if the component is removed for access only.

Torque Specifications:
- Stage 1: 60 Nm
- Stage 2: 120°
To aid reassembly, mark the fitted position of the components prior to disassembly.
CAUTION: Discard the nut.

General Equipment: Suspension Spring Compressor

Renew Part: Shock absorber upper mounting nut Quantity: 1.

Torque Specification: 30 Nm
NOTE: Note the orientation of the components prior to removal.

Inspect the components and renew if damaged or worn.