Removal And Installation: Removal
WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Nuts and bolts must be tightened with vehicle at normal ride height.
NOTE:
- Some variation in the illustrations may occur, but the essential information is always correct.
- Some components shown removed for clarity.
- Removal steps in this procedure may contain installation details.
-
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
- Remove the front wheel and tire.
For additional information, refer to: Wheel and Tire .
-
CAUTION: Discard the nut.
Torque Specification: 60 Nm
-
CAUTION: Discard the nut and bolt.
Torque Specification: 60 Nm
Torque Specifications:
- Stage 1: 60 Nm
- Stage 2: 120°
-
CAUTION: Discard the nut.
Torque Specification: 48 Nm
-
NOTE: If equipped.
-
CAUTION: Discard the nuts.
Torque Specification: 27.5 Nm
To aid reassembly, mark the fitted position of the components prior to disassembly.
-
WARNING: Always follow the spring compressor manufacturer's instructions.
Suspension Spring Compressor
-
CAUTION: Discard the nut.
Torque Specification: 30 Nm
-
NOTE: Note the orientation of the components prior to removal.
Inspect the components and renew if damaged or worn.