Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Steps 1, 2 and 3 are only required if the components were previously removed.

Install the Manifold Absolute Pressure (MAP) sensor.
Torque Specification: 5 Nm
Install the wiring harness brackets.
Torque Specification: 7 Nm
Install the throttle body assembly. Install a new seal.
Renew Part: Throttle body to intake manifold seal.

Torque Specification: 12 Nm
Install the intake manifold assembly. Install a new gasket.
CAUTION: Bolts must be tightened in the sequence illustrated.

Renew Part: Intake manifold seals Quantity: 8

Torque Specification: 12 Nm
Install the front intake manifold support bracket.
Torque Specification: 12 Nm
Install the rear intake manifold support bracket.
Torque Specification: 12 Nm
Secure the intake manifold air intake hose.
Connect and secure the glow plug wiring harness.
Secure the coolant hose.
Torque Specification: 7 Nm
Install the fuel supply pipe brackets.
Torque Specification: 7 Nm
Connect the Emergency Park Release (EPR) cable.
Torque Specification: 7 Nm
Install the high pressure fuel rail shield.
NOTE: If equipped.

Torque Specification: 10 Nm
Install the Exhaust Gas Recirculation valve.
Refer to: High Pressure Exhaust Gas Recirculation Valve .
Install the left side secondary bulkhead panel.
Refer to: Secondary Bulkhead Left Panel - INGENIUM I4 2.0L Diesel .
Connect the startup battery ground cable.
Refer to: Battery Disconnect and Connect .
Bleed the fuel system.
Refer to: Fuel System Bleeding .
Install the engine cover.
Refer to: Engine Cover - INGENIUM I4 2.0L Diesel .