Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

Raise and support the vehicle on a suitable 2 post lift.
Refer to: Lifting .
Remove the accessory drive belt.
Refer to: Accessory Drive Belt .
Remove the charge air cooler.
Refer to: Charge Air Cooler .
- Disconnect the electrical connector.
- Release the 2 wiring harness clips.
- Release the wiring harness clip.
- Remove the charge air cooler mounting bracket nuts.
Remove the charge air cooler mounting bracket.
Install the special tool as illustrated.
CAUTION: Make sure that the special tool is correctly located.
- Special Tool(s): JLR-303-1630
Remove the crankshaft pulley bolts.
- Remove the special tool.
  Special Tool(s): JLR-303-1630
- Remove the crankshaft pulley.
Remove the accessory drive belt idler pulley.
Remove the accessory drive belt idler pulley.
Remove the engine front cover.