Brake Master Cylinder: Removal

WARNING: Do not allow dirt or foreign liquids to enter the reservoir. Use only new brake fluid of the correct specification from airtight containers. Do not mix brands of brake fluid as they may not be compatible.

CAUTION: If brake fluid is spilt on the paintwork, the affected area must be immediately washed down with cold water.

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.
Left shown, right is similar.

Raise and support the vehicle on a suitable 2 post lift.
Refer to: LIFTING
Remove the brake fluid reservoir.
Refer to: BRAKE FLUID RESERVOIR
CAUTION: Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the brake pipes.

Torque : 17 Nm
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove and discard the nuts.
  Renew Part: Brake master cylinder nut(s) Quantity: 1.
  
  Torque : 25 Nm
- Remove and discard the seal.
  Renew Part: Brake master cylinder seal(s) Quantity: 1