Secondary Bulkhead Right Panel - TDV6 3.0L Diesel (G1879662): Removal

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

Disconnect the startup battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT
Remove the engine cover.
Refer to: ENGINE COVER - TDV6 3.0L DIESEL
Remove the cowl panel.
Refer to: COWL PANEL
Drain the engine coolant.
Refer to: COOLING SYSTEM DRAINING AND VACUUM FILLING (G1822256)
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the 4 bolts.
- Remove the engine compartment brace.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Disconnect the 2 electrical connectors.
- Release the engine wiring harness from the bulkhead panel.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Release the engine wiring harness cover.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the 4 bolts.
- Release the 3 wiring harness clips.
- Remove the rear engine cover.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the 3 bolts.
- Release the pipe clip.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the bolt.
- Release the wiring harness clip.
- Remove the wiring harness bracket.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Disconnect the brake booster vacuum pipe quick release connector.
- Release the vacuum pipe from the bulkhead panel.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Disconnect the ground cable connector.
- Release the clip.
- Release the fuel filter and move aside.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Disconnect the 4 coolant hoses.
- Remove the 2 bolts.
- Remove the coolant pipe assembly.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the 5 bolts.
- Remove the secondary bulkhead right panel.