LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2023 >> XF R-Dynamic SE >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Body Panel System - Body Closures -- XF/(X260) >> Body Closures (G1861181) >> Diagnosis And Testing >> Luggage Compartment Lid (G2218355) >> Module DTC Verification And Testing (Luggage Compartment Lid) >> Pinpoint Test Q: Anti-Trap Sensor Test

Pinpoint Test Q: Anti-Trap Sensor Test

  1. Q1: ANTI-TRAP SENSOR TEST 
    NOTE: Before beginning this pinpoint test it may be useful to complete Pinpoint Test S, if not already completed
    1. Inspect the anti-trap sensors on either side of the luggage compartment lid. Pay particular attention to the radius at the top of the luggage compartment lid

      Is there evidence of abrasion/wear and tear?

      Yes:  Using the Jaguar Land Rover Approved Diagnostic Equipment, check datalogger signal - Anti Pinch Seals Voltage D902 when the luggage compartment lid is closed. If the signal indicates that the sensor is activated, refer to the relevant article of the repair information and install a new sensor as necessary

      On the warranty claim please quote feedback ID "FID 5.3"

      No:  GO to  Q2.

  2. Q2: ANTI-TRAP SENSOR TEST 
    1. Inspect the end of the anti-trap sensors on either side of the luggage compartment lid, where the wire exits the sensor

      Is there evidence of wear and tear or insulation break through?

      Yes:  Refer to the relevant article of the repair information and install a new anti-trap sensor as necessary

      On the warranty claim please quote feedback ID "FID 5.4"

      No:  GO to  Q3.

  3. Q3: ANTI-TRAP SENSOR TEST 
    1. Inspect the anti-trap sensors on either side of the luggage compartment lid. Pay particular attention to the radius at the top of the luggage compartment lid

      Is there evidence of abrasion/wear and tear?

      Yes:  Using the Jaguar Land Rover Approved Diagnostic Equipment, check datalogger signal - Anti Pinch Seals Voltage D902 when the luggage compartment lid is closed. If the signal indicates that the sensor is activated, refer to the relevant article of the repair information and install a new sensor as necessary

      On the warranty claim please quote feedback ID "FID 5.5"

      No:  GO to PINPOINT TEST R .