Pinpoint Test N: Latch Test
- N1: LATCH TEST NOTE: Before beginning this pinpoint test it may be useful to complete Pinpoint Test S, if not already completed
- Open the luggage compartment lid to a fully open position. Press the global close switch to close the luggage compartment lid under powered operation. When the latch engages onto secondary latched (first click) position listen carefully for the soft close actuator. The soft close actuator should initiate and pull the luggage compartment lid to a primary latched (fully closed) state
Is the luggage compartment lid in primary latched (fully closed) state?
Yes: No further action required
On the warranty claim please quote feedback ID "FID 4.17"
No: GO to N2.
- Open the luggage compartment lid to a fully open position. Press the global close switch to close the luggage compartment lid under powered operation. When the latch engages onto secondary latched (first click) position listen carefully for the soft close actuator. The soft close actuator should initiate and pull the luggage compartment lid to a primary latched (fully closed) state
- N2: LATCH TEST
- Open the luggage compartment lid
- Refer to the relevant article of the repair information and remove the latch cover
- Using a rubber mallet, gently tap the latch and listen for any mechanical resetting noise
- Press the luggage compartment lid global open/close switch to power close the luggage compartment lid
Does the luggage compartment lid close to primary latch position after soft close actuation?
Yes: GO to PINPOINT TEST K . And repeat once more - if failure mode persists raise an electronic product quality report (EPQR) to seek technical support from DTS or JLR Engineering
No: Refer to the relevant article of the repair information and install a new latch as necessary
On the warranty claim please quote feedback ID "FID 4.18"