LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2023 >> F-Pace Base >> Repair and Diagnosis >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling - INGENIUM I4 2.0L Petrol/INGENIUM I4 2.0L Petrol PHEV -- F-Pace/X761 >> Engine Cooling - INGENIUM I4 2.0L Petrol/INGENIUM I4 2.0L Petrol - PHEV (G2498297) >> Removal And Installation >> Auxiliary Coolant Pump (G2034835) >> Removal

Auxiliary Coolant Pump (G2034835): Removal

NOTE:
  • This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
  • This procedure contains illustrations showing certain components removed to provide extra clarity.
  1. Raise and support the vehicle on a suitable 2 post lift.

    Refer to: LIFTING .

  2. Partially drain the cooling system.

    Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING (G1998221)  .

  3. See Figure
    G15620932Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Release the coolant valve assembly.

  4. See Figure
    CAUTION: Be prepared to collect escaping coolant.
    G15620933Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Release the clips and disconnect the 2 coolant hoses.

  5. See Figure
    G15620934Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Disconnect the electrical connector.

  6. See Figure
    NOTE: Do not disassemble further if the component is removed for access only.
    G15620935Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Remove the auxiliary coolant pump mounting bracket.

  7. See Figure
    G15620936Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Remove the auxiliary coolant pump.

scientia non olet · About LEMON Manuals