GLOVEBOX (G2730481): Removal

CAUTION:

Do not use excessive force to remove the component. Make sure that all fixings are fully released.
Take extra care not to damage the surrounding trim panels.

NOTE:

This procedure contains illustrations showing certain components removed to provide extra clarity.
This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations for left hand drive vehicles, right hand drive vehicles are similar.

Remove the floor console side trim panel.
Refer to: FLOOR CONSOLE SIDE TRIM PANEL
Disconnect the 12 V system.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the 3 fasteners.
- Release the 2 clips.
- Disconnect the electrical connector from the footwell lamp.
- Remove the instrument panel lower trim.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Reposition the door aperture seal to get access to the side panel.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Release the 8 clips.
- Remove the side panel.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the 2 screws.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
1. Open the glovebox lid.
2. Remove the 5 screws.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the 4 screws.
- Reposition the glovebox to get access to the electrical connectors.
- Disconnect the electrical connector from the glovebox lamp.
- Disconnect the electrical connector from the glovebox switch.
- Release the wiring harness clip.
- NOTE: If equipped.
  
  Disconnect the air duct from the glovebox.
- Remove the glovebox.