Transfer Case Rear Output Seal: Removal

WARNING: This page is about a different variant/trim than selected.

NOTE:

Some variation in the illustrations may occur, but the essential information is always correct.
Some components shown removed for clarity.

WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

Raise and support the vehicle.
Refer to: REAR DRIVESHAFT - AWD
CAUTION:
- Discard the nut.
- Discard the seal.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Special Tool(s): 205-053
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Using a suitable tool, remove the output flange.
WARNING: Be prepared to collect escaping oil.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Carefully remove and discard the oil seal.
CAUTION: Make sure that the Jaguar approved cleaning fluid (Loctite 7063) is used to clean the mating faces.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Make sure to thoroughly clean the output flange splines.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Clean the seal register and thoroughly inspect for damage.