Transfer Case Rear Output Seal: Installation

WARNING: This page is about a different variant/trim than selected.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Using the special tool, install a new output shaft seal.

Special Tool(s): 307-520 , JLR-307-695

Renew Part: Transfer case rear output shaft oil seal Quantity: 1 .
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Apply a 1 mm diameter bead of Loctite 648 to the output flange splines 10 mm inner end before installing the flange.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
CAUTION:
- Install a new seal.
- Install a new nut.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Special Tool(s): 205-053

Renew Part: Transfer case rear output shaft flange nut Quantity: 1 .

Renew Part: Transfer case rear output shaft flange oil seal Quantity: 1 .

Torque : 160 Nm
CAUTION: A new breather vent must always be installed.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
Refer to: REAR DRIVESHAFT - AWD
Refer to: TRANSFER CASE FLUID LEVEL CHECK